Event: Descaling System Hood Swiveling Cylinder - Up (Extend)

For previous sequences in this event see the event “Roll Change HPU – On.”

 

1)    Directional Control Valve 302.37 is energized to the parallel flow pattern allowing pressurized hydraulic fluid to flow through the valve, passing from P to A. Next, the fluid flows freely through the A-port check valve of Dual Pilot Operated Check Valve Module 172.25 and the A-port check valve of Dual Flow Control Valve Module 179.25 and into the cap end of Descaling System Hood Swiveling Cylinder 650 causing the cylinder to extend.

2)    Exhaust fluid from the rod end of the cylinder is forced by the B-port check valve of the flow control module to flow through the B-port needle valve of the module, thereby achieving meter-out speed control of the extension speed of the cylinder.

3)    Next, the exhaust fluid flows through the B-port check valve of the pilot operated check valve module, which has been piloted open by pilot pressure from the A-side of the circuit.

4)    Finally, the exhaust fluid flows through the directional control valve, passing from B to T, then back to tank through Check Valve 122.07 and Duplex Return Line Filter 045.01.